Camera Controls : Camera Control Units : Panasonic - AK-UCU500

Rack-mounted Camera Control Unit

Model: AK-UCU500

Optical fiber transmission of uncompressed video signals over a distance of approximately 1.24 miles between camera and CCU
Compact lightweight unit measures 2U in height and is rack-mountable
Supports IP streaming (100 Base-T)
An SD memory card can be used for saving user files and updating firmware versions
Supported formats:

More Product Information Below

Compare

Project List

Product Info

Tech Specs

Documents

The single 2U rack-mounted camera control unit provides a parallel UHD and HD/SD output over a distance of 2000m. The AK-UCU500 camera control unit (CCU) supports both 4K and HD formats. It enables users to configure high-quality, long-distance optical fiber transmission camera systems at a reduced cost.

Optical fiber transmission of uncompressed video signals over a distance of approximately 1.24 miles between camera and CCU
Compact lightweight unit measures 2U in height and is rack-mountable
Supports IP streaming (100 Base-T)
An SD memory card can be used for saving user files and updating firmware versions
Supported formats:
4K (3G-SDI x 4)*4 : 3840 x 2160/59.94p, 50p, 29.97p*5, 29.97PsF*5, 25p*5, 25PsF*5, 23.98p*5, 23.98PsF*5
HD (3G-SDI) : 1080/59.94p, 50p, 59.94i, 50i, 23.98p over 59.94i*5, 29.97PsF*5, 25PsF*5, 23.98PsF*5, 720/59.94p, 50p
HD (3G-SDI x 4)*6 : 1080/239.76p*5, 200p*5 (High Speed)
SD : 480/59.94i, 576/50i
Input / Output:
SDI OUT x 7, SDI OUT (PM) x 1, VBS x 1, etc.
4K MODE*4 : SDI OUT x 4 (4K), SDI OUT x 3, SDI OUT (PM) x 1, VBS x 1, VBS (PM) x 1
HS MODE*6 : SDI OUT x 4 (HS), SDI OUT x 3, SDI OUT (PM) x 1, VBS x 1, VBS (PM) x 1
RET Input (SDI: 4ch, VBS: 1ch) etc.
LAN-TRUNK output
PROMPT Input (SDI : 1ch, ANALOG : 2ch)

Types of Camera Control - Anti-Shock
Types of Camera Control - Gain

Operating Temperature (Maximum): 104 F
Operating Temperature (Minimum): 32 F
AC Voltage: 240 Volts
Active Power: 500 Watt
Current Draw: 1.46 Amps
Depth: 15.79 in
Height: 3.46 in
Width: 16.69 in
Product Weight: 19.40 lbs
Humidity: 10% to 90% (no condensation)
Video Output:
3G/HD/SD-SDI: 7 lines (embedded audio is supported only for HD signals)
HD/SD-SDI: 1 line (shared with picture monitor output*1 ;
embedded audio is supported only for HD signals)
Analog composite: 2 lines (1 line shared with picture monitor output*1)
HD TRUNK Output: HD-SDI: 1 line (cannot be used in UHD/HS mode)
Return Input:
3G-HD/HD/SD-SDI: 4 lines (RET1 input has active-through output)
Analog composite: 1 line
Prompter Input:
HD-SDI: 1 line (with active-through output)
Analog composite: 2 lines (through output of 1 and input of 2 share the connector*1), It is not terminated when the unit is turned OFF. No through output.
Reference Input: BB (black burst) / tri-level*2: 1 line (automatic termination, connect to upper connector; BB signal and tri-level signal automatically recognized, with loop-through output)
Microphone Output: 0 dBm/600 ohm, 2 lines (XLR, 3-pin, male)
Communication:
Intercom input/output (ENG / PROD, 0 dBm, 600 ? (4 W) / 1 V [p-p], 200 ? (RTS), 4 W / RTS / CLRCOM) : 2 lines*1
PGM input (0 dBm/600 ?) : 2 lines
Tally input (red, green, yellow) : 1 input each
Aux:
WFM control
6-bit (open collector output, terminal shared with camera microphone gain setting*1)
Camera microphone gain setting input
5-bit (photo-coupler input, terminal shared with WFM control*1)
Down-conversion system setting input 2-bit (photo-coupler input)
Trunk:
RS-422 / RS-232C
2 lines
FRONT ROP:
RS-422
1 line, 16 V DC output (only one of this and REAR ROP can be selected at one time via the menu or the [ROP FRONT/REAR] selection switch on the front panel)
REAR ROP:
RS-422
1 line, 16 V DC output (only one of this and FRONT ROP can be selected at one time via the menu or the [ROP FRONT/REAR] selection switch on the front panel)
MSU:
RS-422
1 line, GPI for control
LAN TRUNK:
LAN connection with camera side via an optical cable*3
1 line, 100BASE-T, 1000BASE-T
LAN:
Personal computer connection for distribution via the Web*3
1 line, 10BASE-T, 100BASE-TX (use a crossover cable when connecting directly with a personal computer)