Lighting Control Systems : Related Lighting Control Products : Lutron Electronics Company, Inc. - GT-AD-WH

Companion Device for Dimmer/Switch

Model: GT-AD-WH

companion device works with dimmer or switch
Simple touch control
Distinctive architectural aesthetic
Softly lit white LEDs indicate light level and coordinate with any decor
Models available with or without Clear ConnectR RF wireless technology

More Product Information Below

Compare

Project List

Product Info

Tech Specs

Related Products

Documents

GT-AD-WH is a companion device works with dimmer or switch.

companion device works with dimmer or switch
Simple touch control
Distinctive architectural aesthetic
Softly lit white LEDs indicate light level and coordinate with any decor
Models available with or without Clear ConnectR RF wireless technology
Advanced microprocessor dimming technology for control of dimmable LED lamps
Low-end and high-end trim are available for improved
Installs in single-pole or multi-location applications. Companion devices are available for multi-location control with dimmers.
Use LutronR GRAFIK TTM wallplates. All controls come with white wallplate. Other colors and finishes are sold separately
LutronR GRAFIK TTM wallplates snap on with no visible means of attachment

Warranty - Yes
Spec Sheet available - Yes

Operating Temperature (Maximum): 104 F
Operating Temperature (Minimum): 32 F
Certifications: UL, FCC
AC Voltage: 120 Volts
Color: White
Warranty (Length/Type): 1 Year Limited
Typical Power Consumption:
- Companion device: 0.1 W
- Test conditions: load is off
Environment:
- Relative humidity: 0% to 90% non-condensing
- For indoor use only.
Performance:
- Power failure memory: should power be interrupted, the control will return to its previous state when power is restored.
- Tested to withstand surge voltages without damage or loss of operation, in accordance with IEEE C62.41-1991 Recommended Practice on Surge Voltages in Low-Voltage AC Power Circuits.
- Tested to withstand electrostatic discharge without damage or memory loss, in accordance with IEC 61000-4-2.
- Dimmers / Switches communicate with PicoR wireless controls or Radio Powr SavrT sensors through Radio Frequency (RF) and must be located within 30 ft (9 m) of these devices (GTJ models only). Companion devices do not have Clear ConnectR RF technology and are not required to be within a specific range of these devices.
- Uses conventional 3-way and 4-way wiring.
- Total multi-location wire length (blue wire) between all units must not exceed 150 ft (45 m).
Application Requirements:
- When using LEDs, only Lutron® approved lamps marked or rated as Dimmable can be used.
- If using LED bulbs, they must be Lutron compatible! For compatibility and performance information, visit our website at www.lutron.com/led, which is constantly being updated.
Mounting:
- Requires a U.S. wallbox. 3-1/2 in (89 mm) deep recommended, 2-1/4 in (57 mm) deep minimum.